|
|
Receiver Technical Information
I bought an R6016HF receiver to use in small gliders. I was setting one up with two Dymond servos on flaperon and a HS65HB for elevator. I put in the D47s first and they work perfectly. When I connected the hs65 it wandered randomly. I could grab the output arm and turn it by hand to wherever I wanted and it would stay there! I've never seen anything remotely like it. I tried it with 3 different HS65's, 2 used and 1 new. The behavior was identical. So should I send the receiver back to the place I purchased these or direct to Futaba Service USA?
Before you send these back, please check to make sure your receiver is not in high speed mode. Try resetting this to Normal mode, the servos should then work normally!
HS mode is only for Digital servos.
Back to main FAQ/Contact Info page
|
|
